28
SERVICE AND MAINTENANCE
A service manual is available for dealers and service agents
–
contact TA. Service for more information
TA Service recommends that the wheelchair get service at a Dealer or at the factory of TA Service.
! Maintenance and service that are not listed under SERVICE AND MAINTENANCE and ADJUSTMET
shall be done by the service agent, dealer or TA Service.
All programming must be performed by the Dealer or TA Service.
Incorrect program settings or wrong service and maintenance could result in us danger situations where the
wheelchair is uncontrollable or dangerous for the user and the surroundings. This will void the warranty of
the wheelchair.
Only original parts or parts that are approved by TA Service A/S can be used.
Maintenance
When you use the wheelchair it gets loose and worn by use. Therefore is it important that you inspect and
maintain the wheelchair regularly. Especially the armrest, legrest and seat will get loose by movement over
time.
Check regularly, approximately once per month that the screws are intact and tighten.
See section
ADJUSTMENT
Tools:
For general maintenance Allen keys and 8, 10, 13 mm spanners and screwdrivers shall be used.
! Certain repairs can require other tools than the listed tools.
Cleaning.
Coated metal:
Wash coated metal surfaces with a cloth soaked in detergent water, rinse and dry
Plastic:
TA iQ shield can be cleaned with a cloth dampened in household detergent.
Do not use solvents on the shield.
WARNING!!
TA iQ or parts of it will not withstand immersion in water.
Please note that all electrical components do not tolerate water.
TA iQ cannot be washed with a pressure washer
TA iQ cannot be washed with a water hose.
The Wheelchair must always be shut off while cleaning.
Fuse
On the side of the lifting column, on top of the shield is an overload protection (Fig. 1).
Fuse cuts power if the power chairs maximum consumption exceeds 80A
Summary of Contents for 97050
Page 22: ...22...
