TA Service 97050, User Manual

Page: 2 / 32

2
WARNINGS.
Please read the instructions carefully. They contain important warnings and instructions.
TA iQ power chair is not intended for users with a weight exceeding 140 kg.
TA iQ power chair should always be turned off when getting on or off of the chair and when assisted by a
helper, so that the power chair does not accidentally move if the joystick is activated.
Do not reach into or under the power chair when the seat lift or seat tilt is activated, because there is a risk of
entrapment of hand and fingers between the mechanical parts.
Check that others, especially children, aren’t too close to the power chair when the seat lift or seat tilt is
activated.
The power chair is EMC tested. However, it is possible that the power chair can be affected by
electromagnetic fields from electronic devices, such as mobile phones. Similarly, it cannot be excluded that
the chair can emit electromagnetic fields that can affect the surroundings, such as alarm systems in stores.
Pay particular attention to late run when driving on ramps.
When the power chair's brakes are disengaged, the power chair may roll if it is on a sloping surface.
Slowing down by pressing the On /Off button creates the risk that the user's torso could fall over.
This could lead to, the user falling out of the power chair.
Slowing down in this manner should be avoided on sloping surfaces and ramps.
When forcing level differences, it is important that the power chair runs perpendicular to the obstacle in
order to minimize the risk that the power chair should tilt.
By forcing level differences with the seat tilted or hoisted there is a risk that the power chair can tip over. By
forcing level differences, it is therefore important that the seat is elevated as little as possible and is as close
to an upright position as possible to minimize this risk.
Driving on slopes should be avoided because a slope to the side will give a risk that the power chair can tip
over.
When driving on slopes, seat should not be lifted to keep the power chair's stability.
When the power chair is used as a seat in a car, bus or similar, the power chair must always be secured with
an approved car attachment. Using 4 point car attachment the hooks must only be attached in the 4
attachment loops on the power chairs. Fastening the hooks elsewhere will cause a high risk of danger to the
user and damage to the power chair. When using a Dahl docking system the instructions from Dahl
Engineering must be followed closely. Failure to follow instructions carefully, will cause a high risk of
danger to the user and damage to the power chair.
Avoid touching leaking batteries, as the contents can be harmful.
The temperature of some surfaces can increase and get very hot when in direct sunlight. Especially the
armrest, joystick controller, back/seat and footplate surface, care should be taken to avoid touching with bare
skin.
Repairs and programming of the power chair must be performed by TA Service A/S or a repairer who is
authorized by TA Service A/S.
Unauthorized programming can cause the power chair to handle in a way that could cause danger to the user
or the surroundings.
Only original parts or parts that are approved by TA Service A/S can be used.