T-Storm TS 120CC Edge, Instruction Manual

Page: 32 / 40

Now find a point on the rudder hinge line that is in line with one of the horns. Move the horns about
until you find the point at which the horn is central to the hinge line.
Also consider that the centreline of both holes should also be in line with the hinge line. This can be
achieved by taking a rule and lining it through both holes and then pushing it back against the hinge
line.
Eventually you should end up with a dimension half of your previous dimension. In our case it was
45mm.
Put the rudder in a safe place to allow the epoxy to fully cure.
Option 1 – Rudder Push/Pull setup
Use the torch method to locate the servo supports in the rear of the fuselage. Iron around the area
to seal the covering down onto the wood. Carefully cut out the holes out.
30