Wings
Locate the aileron fittings bag from the accessories box. It will contain the items as shown in the
image below: -
Note: - If you wish to use the 3 servo per wing option, there is an extra set of horns and back plates in
the spares bag in the accessories box.
Take the horns and back plates and rough up the surfaces with rough sandpaper. This will provide
the glue with a key when it is installed in the aileron.
Repeat this process for all the horns and back plates.
Note: - Decide how many servos you will be using per wing now so that you can cut out the
corresponding area on the wing panel. In this build we are using two servos per wing. We have cut out
the holes closest to the wing root and the wing tip. The third servo location hole is in the centre of the
wing panel.
As we did with the elevators, cut the covering to expose the slots below. Use a single horn to
widen/loosen the wood and, if necessary, use a needle file to remove any excess stubborn glue.
9
Summary of Contents for TS 120CC Edge
Page 1: ...Instruction Manual for TS 120CC Slick Edge Extra...
Page 5: ...3...
