T Scale AW20, Operation Manual

Page: 38 / 56

AW20 Series Weighing Scale Operation Manual
- 33 -

Press key to print out the data.
5.11.2 Receipt Printing
It allows for printing the weighing records to receipt printer.To enable the function, please refer to
setup menu
2.ADVANCED SETTINGS > 7.ACCUMULATION >1. ACCUMULATION MODE >MANUAL
5.INTERFACE >1.SERIAL >1.TYPE >RS232
5.INTERFACE >1.SERIAL >2.MODE >PRINTER
5.INTERFACE >1.SERIAL >4.EXTERNAL PRINTER > TPuP
5.INTERFACE >1.SERIAL >6.BAUD RATE > 115200
5.INTERFACE >1.SERIAL >7.DATA BITS > 8
5.INTERFACE >1.SERIAL >8.STOP BITS > 1
5.INTERFACE >1.SERIAL >9.PARITY > NONE
 Load the weight on the platform.

Press key to print out the data.
NOTE:The baud rate of scale should be consistent with printer.
5.12 Tolerance checking
The weighing scales allow weighing goods according to a target quantity or target weight or target
percentage within specified tolerances. With this function one can also check if the weighing good is within
a defined tolerance range. Reaching target quantity is indicated by an audio sound (if enabled in menu) and
a visual color bar.
Note: Check weighing or counting available only when weight more than 20d
5.12.1 Beep Mode
The beep sound depends on the settings made in menu block
Options:
6.Beep
mode
1.OFF Beep sound turned off
2.BEYOND LIMITS Beep sound will ring out when load is beyond tolerance range
3.WITHIN LIMITS Beep sound will ring out when load is within tolerance range
4.BELOW MIN.LIMIT Beep sound will ring out when load is below low limit
5.ABOVE MAX.LIMIT Beep sound will ring out when load is exceed high limit
Optical signal:
The curve bar in the display shows whether the goods to be weighed are within the two tolerance limits.