3
EN
FR
ES
• If you are ironing a fabric comprising a mixture of fibres: adjust the temperature
to the most delicate fibre.
• If you put your thermostat in the
“MIN”
position, the iron does not become hot.
Using the water spray trigger
(spray)
• When ironing with the steam or dry function, press the spray trigger several times
in succession to remove stubborn wrinkles –
fig.6.
Obtaining more steam
• Set the thermostat control to
“MAX”
or
“
•••
”.
• Press the turbo steam button from time to time –
fig.7.
• To avoid water dripping onto your clothes, wait a few seconds before pressing again.
Smoothing garments vertically
• Hang the garment on a hanger and hold the fabric using one hand. The steam
is very hot so you should always do this with the garment on a hanger – never
while someone is wearing it.
• Set the thermostat control to
“MAX”
–
fig.8.
• Pulse the turbo steam button
–
fig.7
and move from top to bottom –
fig.9
.
Dry Iron function
• Adjust the temperature to the fabric being ironed.
• Set the steam control to
–
fig.1.
• You can iron when the light goes out.
Additional functions
Gliss/Glide Protect autoclean soleplate
(depending on model)
• Your iron is equipped with a catalytic self-cleaning soleplate.
• Its exclusive coating eliminates impurities generated during normal use.
• It is recommended that you always rest your iron on its support base to preserve its self-cleaning coating.
Auto-stop safety function
(depending on model)
• The electronic system cuts the power and the auto-stop light flashes if the iron
is placed on its support base for more than 8 minutes or left flat for more than
30 seconds –
fig.10.
• To restart the iron, simply shake it gently until the light stops flashing.
Anti-drip function
• The automatic steam selection function is based on the fabric being ironed, which is integrated into your iron,
reduces the steam flow at low temperatures and prevents the iron from dripping onto your clothes.
Cleaning and maintenance
Descale your steam iron easily
• To prolong the steam performance, your iron is equipped with an integrated
limescale collector. This collector, which is located on the iron's support base,
automatically collects limescale that forms inside the iron.
• It is recommended that you clean the collector every 4 months. The amount of
scale collected will depend on the hardness of the water.
• BE CAREFUL: this operation should only be carried out when the iron has been
unplugged for more than one hour and has cooled down completely. To carry
out this operation, the steam iron must be close to a sink so that water can flow
from the tank when opened.
• Hold the iron in one hand and tilt it slightly, pointing the soleplate upwards.
Check that there is
water in the tank before
using the spray trigger.
Hold the iron a few
centimetres from the
fabric so as not to burn
delicate fabrics.
In normal use, the auto-
stop light is on!
Do not put any descaling
products (vinegar,
industrial descaling
agents...) to rinse out
your iron: they could
damage it.
1800129806 FV96XX U0-Q0-X0_110x154 05/12/13 16:41 Page3
