background image

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using the iron.

When using your iron, basic safety precautions should always be followed, including the following:
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull on the
cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect
the iron.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around
iron when storing.
5. Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of elec-
tric shock, do not disassemble the iron. Contact our Consumer Service Department for examination, repair or ad-
justment. Incorrect reassembly can cause a risk of electric shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended
while connected or on an ironing board.
8. Burns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam iron
upside down - there may be hot water in the reservoir.
9. This appliance is only for domestic and personal use.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 15 amp. cord should be used. Cords rated for less amper may
overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS

For your safety

PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE REFERENCE.

This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic Com-
patibility, Low Voltage, Environnement).
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concer-
ning use of the appliance by a person responsible for their safety. Children must be supervised to ensure that
they do not play with the appliance.

• 

During the first few uses, a harmless odour and a small amount of smoke may be given off. This has no ef-
fect on the use of the iron and will disappear quickly.

• Warning ! The voltage of your electrical installation must correspond to that of the iron (120V or 127

V). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the
guarantee.

• If it is absolutely essential to use an extension cable, choose a 15 amp one.
• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to

avoid any danger.

• The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or functions incorrectly. Never

dismantle your appliance : have it inspected by an Approved Service Centre, so as to avoid any danger.

• Never immerse your iron in water !
• Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rinsing the

water tank, before cleaning it, after each use.

• Never leave the appliance unattended when it is connected to a power source or if it has not cooled down for

approximately 1 hour.

• Your appliance gives off steam, which may cause burns. Take extra care especially when you are ironing close

to the edge or on a corner of your ironing board. Never direct the steam towards people or animals.

• Your iron should be used and placed on a flat, stable, heat-resistant surface. When you put your iron onto its iron

rest, make sure that the surface on which you put it is stable. 

• This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to com-

ply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.

1800129806 FV96XX U0-Q0-X0_110x154  05/12/13  16:41  Page1

Summary of Contents for ULTIMATE ANTI-CALC FV9640X0























Reviews: