T E E F O R M I N G M A C H I N E
17
T-60
T
h
e
s
p
e
e
d
s
1. Speed selector
2. The feed mechanism lever
The speed selector
knob is on the top of the gearbox of the T-60. Slow
speed is marked “I” and fast speed is marked “II”. To shift from fast to slow
speed, turn the selector knob 180 degrees. Drilling is always done in fast
speed (II). The forming of the tee is done in either slow speed or fast
speed depending on the run tube and outlet sizes. See the chart in
chapter 11.
If the speed selector knob does not engage smoothly, rotate the
motor by “bumping” the trigger.
The feed mechanism lever
is situated near the chuck-ring. The feed
mechanism is engaged (on) when the lever is turned downward, i.e. as
shown on the illustration.
If the feed mechanism lever does not engage smoothly, rotate the
motor by “bumping” the trigger.
Do not force lever.
