T+A R 1230 R, User Manual

Page: 35 / 58

35
Direct control of the CD player
Playing a CD
•
Open the CD drawer (     button)
•
Place the CD in the drawer, printed face up
• Close the CD drawer (

 

button)
Immediately after you close the drawer the CD player
reads the Table of Contents of the disc; the screen
shows the message
'READING' , and during this period
the unit ignores any button-presses.
After this period the screen displays the current operati-
onal mode and the total number of tracks on the CD in
the machine, e. g.:
'STOP 16' .
• Start the playback process (     button)
Playback begins and the screen shows the operational
state and the number of the currently running track:
'PLAY 01' .
At the end of the final track the CD stops playing and the
screen shows
'STOP' again, together with the total num-
ber of tracks on the CD.
Variations:
If you press the     button after placing a CD in the
drawer, the drawer closes and playback starts with the
first track.
You can interrupt playback at any time by pressing the

 
 button. During the interruption the screen shows
the message 'PAUSE' .
Playback continues when you press the

 

or
    button again.
If you press the     button briefly during playback,
the player jumps to the start of the next track.
Pressing the     button briefly during playback cau-
ses a jump to the start of the previous track. If the button
is held pressed in, the machine jumps back several
tracks.
During a jump to the next or previous track the screen
displays the message:
'JUMP' .
Pressing the     button briefly halts the playback
process; screen display: 'STOP' .
Pressing the     button briefly opens the CD drawer.
Note:
If there is a CD in the drawer, play-back starts automa-
ticly when you switch on the device or select CD as new
source-device.
Track selection
During playback
Press the     or     button repeatedly, or hold
the button pressed in, until the number of the track you
wish to play appears on the screen after the
'PLAY'
message.
Playback is interrupted briefly when you release the
button; the screen shows
'JUMP' and then the track you
have selected is played.
Note:
You can also enter the number of the track you wish to
listen to directly using the numeric buttons on the remote
control handset.
Repeating a passage (A-B)
The first step is to search for the starting point of the
passage you wish to repeat:
The screen shows a flashing letter 'A' in front of the
current track number inviting you to set the start marker:
'PLAY AB 08' .
Press the     button briefly to set the start marker.
After a short period you will see a flashing letter 'B' ,
inviting you to set the end marker: press the    
button again at the end of the passage you wish to re-
peat.
The CD player now repeats the passage between the
two markers until you press the
    button.
Notes:
• You can use the fast forward / rewind buttons

 

and     to search for the start and end points of
the passage.
•
During the A-B repeat process all the buttons which
usually control the CD mechanism -     /
    /     /     /     are ignored.