T+A FD 100, User Manual

Page: 30 / 36

30
Creating the Radio Link (Pairing)
Pairing The FD 100 needs to be linked to the Gateway / device to be con-
trolled; this only has to be carried out once. This is the procedure:
•
Set your machine / RC Gateway to Pairing mode, as described
in the instructions supplied with it.
•
Open the System Settings menu on the FD 100 with a long
press on the
   
button.
•
Select the “Start Pairing” point. The remote control handset now
automatically searches for the device / RC Gateway.
•
When it locates the device / RC Gateway, the screen displays
the message ‘Pairing successful’. If you wish, the name of the
device / RC Gateway can be changed at this point.
•
Press the
   
button to confirm your action.
•
In the following step you can assign the device / RC Gateway to
a Hotkey for faster access.
•
Select a button (or no button, if you prefer), then confirm your
choice by pressing the

 

button.
•
The FD 100 is now linked to the device, and is ready for use.
   
If it proves impossible to create a radio link, there may be several
reasons. The possible errors are listed in the following table:
Screen display Error
There is no response The device / RC Gateway is not in
Pairing mode.
The RC Gateway is not switched on
(plug-type mains PSU).
Currently no active
device … The E-Link, R-Link or RS 232 con-
nection with the device is not present.
The software installed in the device
you wish to control is not suitable.