T+A DD 1535 R, Operating Instructions Manual

Page: 42 / 64

42
DVD player as digital sound and picture source
The components of your system should be connected as
shown in wiring diagram
3
. This is the procedure:
•
Connect the digital SURROUND sound output of the
DVD player to the digital input ( DIGITAL INPUT 3 ) of
the DD 1535 R using a co-axial digital lead.
Notes:
- Be sure to set the digital output of your DVD player
to surround mode.
- If the digital output of your DVD player is set to
“ PCM ”, the DVD player will only generate a digital
stereo signal. In this mode the DD 1535 R cannot
carry out any surround decoding!
•
Use an audio cable to connect the Analogue OUT
sockets on the DVD player to the DVD sound inputs
of the
DD 1535 R .
•
If you also wish to use the DVD player as a high-
quality CD player, connect its analogue output to the
pre-amplifier input
CD
.
•
Connect the die S-Video OUT socket of your DVD
player to the S-Video IN socket on the decoder using
a S-Video lead.
Note:
If your DVD player only features a SCART socket,
connect it using a SCART / S-Video adaptor.
• Connect the R
LINK
socket on the DVD player to the
R LINK
socket on the decoder; if this is already in use
by another source device, connect the lead to the
vacant
R LINK
socket on the second source device.
• Finally connect the mains power supply and switch
the system on.
Note:
If your DVD player features a Component Video (YUV)
output, you can also use this to connect to one of the
YUV inputs of the
DD 1535 R in addition to the S-Video
connection (see Wiring Diagram 4).
All manuals and user guides at all-guides.com