T+A CALA CDR, User Manual, Page: 18 / 72

18
The

button is used to switch between numeric and alpha-numeric
input, and between capitals and lower-case letters. Letters can be erased
by pressing the

button.
If you should wish to restore the factory default source name, erase the
whole name before saving the empty field with the

button: this
action resets the display to the standard source names.
Sub-point
Auto-power-on
This menu point enables you to automatically switch on the
due to the automatic power-on function.
If this function is switched on, the
automatically switches itself
on from standby mode, and switches to the selected source (if
necessary), when a music signal is present at the
Analog In 1,
Analog In 2 or Digital In 1 - 3 input - depending on the input to which the
auto power-on function is assigned.
If the
is switched on, but no signal is detected at the auto
power-on input within about twenty minutes, then the
automatically switches itself off again; however this only occurs if the
auto power-on source is selected.

The automatic power-on function is only active when the Energy Saver
function is disabled.
Sub-point
Passthrough
If you wish to connect a device with its own volume control (e.g. TV set),
this menu point can be used to disable the volume control of the
for the Analog In 1 input (pass-through mode).
 
You should only select this setting if a device with its own volume control
is connected to the unit. Ensure that the volume of the source device is
turned down to zero before connecting it to the
, otherwise the
speakers connected to it may be ruined through overloading.
Sub-point
Phono mode
The purpose of this menu point is to configure the input Analog In 2 for
connecting a turntable fitted with an MM pick-up.
 
Never select this setting unless a turntable (without integrated phono
preamp
– output voltage until 10 mV) is connected to the
,
otherwise the speakers connected to the unit may be ruined through
overloading.