ELECTRIC BICYCLE METER KT
—
LCD4 Product User Manual
- 41 -
C14 parameter setting interface
C14 is the parameters of power-assist tuning setting, with the default value of 2. The
power-assist is between1-4 gear, and it is invalid until P3 equals to 1. The setting range 1-3,
and press
(UP) button or
(DOWN) button for short to make selection.
C14 parameter definition table:
C14 Value
Assist strength of intelligent pedal motor
1
Weak assist strength of motor
2
General assist strength of motor
3
Stronger assist strength of motor
After finishing C14 parameter setting, hold
button
(SW)
long for about 2
seconds to exit C parameter setting environment and return to the display 1.
○
Exit Parameter Setting
Under each parameter setting interface, if there’s no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original parameters will be saved.
Parameter Copy
Set parameters (include general project parameter, P parameter and C parameter) of
all KT-LCD4 meter produced by our company according to requirements, and set the meter
to be a data source according to the method of
"C11 meter attribute selection setting".
Use special wiring cables to properly wire to LCD4 meter needs to be copied
according to the diagram.
