ELECTRIC BICYCLE METER KT
—
LCD4 Product User Manual
- 21 -
Please Note
：
when P2 parameter is set to be 0, for the built-in clutch motor, there will
be the following defects, when the internal motor rotors stop or the internal rotor speed is
lower than the outer rotor speed, then the speed displayed on the meter is inaccurate!
After finishing P2 parameter setting, press
button (
SW
) to save the current set
values, then press
button
(DOWN)
to
enter P3 parameter setting interface.
○
P3 Power Assist Control Mode Setting
Enter P3 parameter setting interface after P2 parameter setting is finished,
press
button
and P3 parameter column flashes.
P3 parameter setting interface
P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "
imitation torque control
" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "
speed control
" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press
button
(UP)
or
button
(DOWN)
for selection. P3 parameter setting
method is the same to that of P2.
