STEP 4- TOP OF THE HEAD
1. Using the attachment comb 3/8” or 1/2” cut the hair at the top of the head from back to front against the
direction in which the hair normally grows (See diagram 4). In some cases, this may require cutting from
front to back.
2. Attachment combs 3 mm or 6mm are used to achieve a close cut or short cut.
3. For longer hair on top use the hair comb provided and lift the hair on the top of the head. Cut over the comb,
with the hair lifted or hold the hair between the fingers to lift it and cut it to desired length (See diagrams 5
and 6). Always work from the back of the head. You can cut the hair shorter gradually by reducing the space
between the comb/fingers and the head. Comb out trimmed hair and check for uneven stands.
STEP 5- THE FINISHING TOUCH
1. Finally, use the cutter without an attachment comb for close trimming around the base of the neck, the sides
of the neck and the ears.
2. To produce a clean straight line at the sideburns, use the hair clipper with the top parts of the blades
pointing straight to the hair.
3. (See diagram 7)
4.
Press the clipper at right angles to the head, tips of the blades lightly touching the skin and work downwards.
This way you will obtain a clean cut.
′
FLAT TOPS & SHORT CUTS
1. Starting with the longest attachment comb (1/2”) to cut from the back of the neck to the crown. Hold the
attachment comb flat against the head and slowly move the clipper through the hair, as shown below.
2. (See diagram 8)
3. Use the same procedure from the lower side to the upper side of the head (as illustrated). Then cut the hair
against the direction in which it grows and then level the cut from the sides.
4. To give a
′
flat top’ look; the hair on top of the head must be cut over the top of a flat comb rather than by
using the attachment comb.
5. Use closer cutting attachment combs to decrease the hair down to the neckline as desired. Comb hair and
check for uneven areas.
Summary of Contents for SY HC25PRO
Page 1: ......
