PAGE
9
S
ection 2
•
T
erminating the wiring
Connecting the system input
Connect the cable marked with the zone
name to the system input of the speaker
following the wiring shown below:
System input
Main connection from hub
Connecting the keypad
Note:
For IR equipped speakers; the
connection of the KPM1 keypad is
optional.
Keypad
Connects to keypad
Connect the keypad cable to the keypad
connection (note only 4 wires are used).
Connecting the feed to the passive
speaker
Left speaker
Connect the cable marked Left speaker to
the left-channel speaker output.
Note:
The doubling up of each coloured
pair of CAT5/6 wires
Spare cable
The spare cable can be used for a number
of purposes including the connection of
a dedicated power supply, a centralised
local input and as a spare if another cable
is found to be damaged.
Note:
No connections are normally made
to the power supply input of the speaker
when used as a main zone. This is because
power is normally relayed via the system
input cable.
2.5 Connections required
for additional
functionality
Local input
Depending on the wiring scheme,
provision might have been made for a
local input. This is one that is exclusive to
the zone. A local input maybe connected
locally in the room, or it may be connected
centrally alongside the hub. Either way,
the local connection must be made at this
point.
Please also note that all eight wires are
connected as this allows an IRM module
to be connected alongside a SIM module
to facilitate IR control of the local source.
If only a single SIM is being fi tted with
no IRM then ensure that the 4 unused
cables are cut back and/or insulated at the
module end of the cable:
Local Audio
From SIM
Local IR
From IRM
