sLAN/all-PoE
User Manual
11
5. Get Started
An Ethernet port is required to connect sLAN/all PoE to the network. Ethernet supports 10Mbps and 100Mbps Ethernet
connections. The LAN port on sLAN/all PoE supports MDIX feature, which automatically recognizes Cross Ethernet Cable
and Direct Ethernet Cable, so it does not matter which cable users connect. Connect one end of the cable to the sLAN/all
PoE and the other to the network equipment.
6. How to Connect
The following methods are used to connect sLAN/all-PoE to devices and networks:
Power On for the First Time
First, check if the input voltage supplied to sLAN/all PoE matches the specification of the model and supply the correct voltage.
sLAN/all POE turns on and starts booting only when the power is normally supplied.
There are RDY, TXD/RXD LED for checking operation status.
(Please refer to Chapter 3. Product for LED status)
To access the web of sLAN/all PoE, an IP address is required. A static IP is assigned to the sLAN/all PoE as default. You can
manually enter other IP address after the initial access, or set up sLAN/all PoE to automatically assign an IP address from
DHCP server. This depends on your network environment or policy, but it is strongly recommended to assign your own static
IP to sLAN/all PoE.
Access
To view or set up the environment of sLAN/all PoE, you should access to Web browser or use setup utility. This manual is
based on how to set it up through the Web browser.
(Please refer to the SGConfig manual for instructions on how to use the setup utility)
You should first know the IP address, the network address where sLAN/all PoE is operating.
In case the LAN port of sLAN/all PoE is in use with an IP assigned by DHCP server, or it is set to a static IP address, or if you
do not know the IP address, sLAN/all PoE provides the following methods:
Default IP Address: 192.168.0.223
The default IP address of sLAN/all PoE is set to 192.168.0.223. To connect to this address, you should change your network
settings so that your PC can access 192.168.0.223. Please refer to the following example for settings:
