699-41-20.1
-
31 -
Fig. 22 Lubrication point for the Guide shaft lubrication, (1): felt strip, (2): grease
nipple
Lubrication interval
Initial lubrication after approx. 2000 hours run.
Next interval: Every 1000 hours run.
Lubricant
Recommended lubricants:
Oil with a viscosity of approximately 200 mm²/s at T = 40°C
e.g. SAE90 gearbox oil.
Lubricant quantities
approx. 0.4-1.5 cm³ depending on size
6.7.11.2
Spindle lubrication
Spindle lubrication
The spindle is lubricated via the front face of the guidance slide. To do
this, the guidance slot is driven out from the drive side to the rear end
position. The grease is fed via the grease nipple (1) to the grease nut (2)
and distributed in small quantities on the spindle.
Grease in two stages. After the first stage, drive the guide slides through
two slide lengths and then top up with the second stage.
Fig. 23 Lubrication point to the spindle lubrication, (1): nipples, (2): lubrication nut
Lubrication interval
Lubrication every 300 km (Recommended lubricating interval taking the
environmental factors and loading data specified in these assembly in-
structions into consideration.)
Lubricant
Recommended lubricants:
Grease in accordance with DIN 51818, Viscosity class: NLGI class 1,
NLGI class 00
