Digital Creasing Machine
- 12 -
Indentation skew adjustment
If the user finds that the paper that is coming out is skewed (Fold the paper along the
indentation line, the sides are not vertical), the side panel of the paper table needs to be
adjusted to change the paper feed angle so that obtain a satisfactory indentation direction.
The side board of the paper feed table is used to adjust the paper feed direction when the
paper is indented, the side board of the paper feed table is fixed to the paper feed table as
shown, and the position can be adjusted.
The side board of the paper feeding table is fixed on the paper feeding table by 3 screws. The
closest to the indentation is a round hole, and the latter two are oval holes.
Loosen the 2 screws at the back and adjust the angle of the side board of the paper table
slightly. The angle of the paper feed direction will be also changed, and the original skew can
be improved.
Note: Normally as long as the paper is at right angles, the side board of the paper table does
not need to be adjusted.
