Synthino XM, Manual

Page: 11 / 14

MIDI Messages
The Synthino XM responds to a wide variety of MIDI messages to control its behavior and
various parameters. MIDI
​
program change
​
messages with values 1­18 can be used to select
the waveform/sample. MIDI ​ pitch bend ​ messages will bend the notes on a channel up to 2
semitones up/down.
The arpeggiator and groovebox mode
​ BPM ​ rate may be controlled with MIDI clock pulses. If
the Synthino XM detects MIDI clock pulses, they will be used to set the rate and the BPM pot
will be ignored until MIDI clock pulses stop arriving. MIDI
​ start ​ and ​ stop ​ messages will start
and stop the arpeggiator and sequencer. The MIDI
​
system reset
​
message will reset the
device.
Control Change Map
CC # MIDI Name Synthino XM Parameter
73 attack time attack time
75 decay time decay time
79 sustain volume sustain volume
72 release time release time
70 sound variation waveform
76 vibrato rate pitch LFO rate
1 modulation depth pitch LFO depth
12 effect control 1 LFO waveform
13 effect control 2 filter LFO rate
91 effects depth 1 filter LFO depth
71 timbre filter resonance
74 brightness filter cutoff frequency
16 general purpose 1 arp/groovebox BPM (alternative to MIDI clock)
17 general purpose 2 arpeggiator note length
18 general purpose 3 arp/groovebox transpose
7 channel volume groovebox track volume
123 all notes off all notes off