3.4
ALERTS Page
The Alerts page gives the user the ability to setup email transmissions for selected alarm conditions.
The email engine uses SMTP, so the user must provide the address of an SMTP server to transmit the
messages. The SMTP server will then decode the email addresses and route the messages accordingly.
If no SMTP server is entered, the MPS will attempt to send the message via the domain of the email user
selected.
Select any items from the list of alarm conditions desired to initiate an email transmission.
Alert configuration is stored in non-volatile memory after the “Save Settings” button is pressed. The
“Send Test Email” button can be used to send a test message to the designated address before
modifying the configuration with the “Save Settings” button.
Email / alert configuration settings can be restored to the factory default values by transmitting the
RS232 command “EMAIL RESTORE”.
Figure E Configure Email Alerts
Figure F Test Email Message Example
