18
Installing the Harness
Slip the harness strap (without metal buckle) through the buckle located at the top, behind the backrest (Fig.
31). Follow Figures 31 to 36 to knot the bottom of the harness.
Installing the SEGO Seat onto the Synetik Hi/Low Base (if applicable)
To facilitate shipping, the Hi/Low Base is positioned at its lowest height. To
complete the installation of the base, you will need to:
1. Release the safety lock by pulling on the handle
A
(Fig. 37) and turning it one
quarter (¼) of a rotation. The handle will remain out.
2. Lock all 4 wheels.
3. Push down gently on the foot pedal to raise the base. Installation of the seat
is facilitated when the base is set at its maximum height.
4. Hold the SEGO seat and position it as per Figure 38. Tilt seat to a 45º angle to
facilitate its insertion.
5. Lower the back of the seat downward. When flat and in place you will hear the lock click. If
no sound, pull the handle on the base interface
A
(Fig. 38).
6. Always check that the seat is properly secured in place by trying to push it forward.
Caution:
Make sure the SEGO Seat is securely installed and fastened onto the Hi/
Low Base. If the seat is not correctly positioned, there is a risk of the Seat coming
off, injuring the user or the person handling the equipment.
Installing SEGO onto a Stroller Frame (if applicable)
1. Install the SEGO Seat interface onto the stroller frame:
•
First slide tube
A
into the hooks
B
(Fig. 39).
•
Push the interface into the slots and lower until the
lock clicks into position.
2. To install the SEGO seat onto the stroller interface, repeat steps 4, 5
and 6 of the installation instructions for the SEGO seat onto the Hi/
Low Base. (Fig. 38)
Caution:
Make sure the SEGO Seat is securely installed and
fastened its base. If the seat is not correctly positioned, there
is a risk of the seat coming off, injuring the user or the person
handling the equipment.
Assembly of Accessories and Options
Installing the Tray
1. Loosen plastic knob
C
, adjust the tray rods
B
to the same width as the
glides located under the armrests
A
(Figs 40 & 41).
2. Retighten tray rod knob
C
3. Insert the metal tray rods B into the glides
A
(Figs 40 & 41).
4. To secure the tray, tighten knobs located under the glides
A
.
Summary of Contents for SEGO
