4
1.
Following the wiring diagram, connect the provided cable between the camera and the
phone unit. Then connect the wires to the corresponding position between camera and
main unit. i.e. Red wire =>1R; White wire => 2W; Brown
Wire=>3B;Yellow wire=>4Y.
2. If the Electronic Door Release is to be used, connect the “Door Open” key to the
terminals as shown 5K1 & 6K2. Another adaptor needs to be connected for the door
lock in order to supply electricity to it. Make sure that the operating current and voltage
between the adaptor and the electronic door lock are the same. E.g. if the operating
voltage and the current for the door strike are 12V &
800mA, the operating voltage and
current need to be 12V & 800mA as well from the power supply of adaptor. Please use
the electronic door lock that the operating current is under 5A.
For the best quality of the image, please follow the below instruction to choose the length of
cable.
Distance between the camera and the monitor
Diameter for each wire inside
the cable
From 1 m to 20 m
0.45mm
From 20 m to 50 m
0.5-0.75mm
Indoor/Outdoor unit installation
1.
Connect 4-
wires to indoor units and the outdoor unit according to the “Cable connection”,
and referr
ing to the “Recommended installation height” diagram(See fig.4) to locate and
mark the screw’s positions onto the wall.(See fig.6)
Fig.6.
V
1R
2W
3B
4Y
5K
1
6K
2
15Volts DC
-
+
