13
«MANUAL» MODE
To set your device, proceed as follows:
- Choose the welding voltage using the 2 power switches (2 & 7 positions)
Example:
For welding Steel - 1 mm
- Set the top switch to "A"
- Set the bottom switch to "1"
For welding Steel - 10 mm
- Set the top switch to "B"
- Set the bottom switch to "7"
- Adjust the wire speed with potentiometer
.
Advice
The wire speed adjustment is often determined by « the noise »: the arc must be stable and emit low
crackling.
If the speed is too low, the arc will not be continuous.
If the speed is too high, the arc crackles and the wire will push back the torch.
« SYNERGIC » MODE
This function automatically controls the wire speed. There is no need to set the wire speed manually.
Position the wire speed potentiometer
in the middle of the« Optimal synergic » zone.
-
Select:
Wire type
Wire diameter
Power mode (2 switches, 2 & 7 positions)
To select the right position in accordance with the thickness of the work-piece, please refer to the
“synergic mode” table on the previous page.
From the settings chosen, the PowerMig 400-4 determines the optimum wire speed and the device is ready to
weld. It is also possible to adjust the wire speed if necessary by adjusting potenti or – manually
.
The last welding configuration is saved in the memory automatically (wire diameter, wire type, mode).
