Symbol LS 4071, Product Reference Manual

Page: 53 / 168

5-9
Parameter Menus
Host Type
RS-232C Host Types
Three RS-232C hosts are set up with their own parameter default settings.
Selecting the ICL, Fujitsu or Nixdorf RS-232C terminal sets the defaults listed
below. These defaults take precedence over Standard RS-232 defaults. So, if
you’ve selected Fujitsu RS-232C, then select the Standard RS-232 defaults,
the Fujitsu defaults still take precedence. To return to the factory set
defaults, scan the SET ALL DEFAULTS bar code on page 5-7.
Table 5-2. Terminal Specific RS-232C
Parameter Standard ICL FUJITSU NIXDORF
Mode A/
Mode B
Transmit Code ID No Yes Yes Yes
Data Transmission Format Data as is Data/Suffix Data/Suffix Data/Suffix
Suffix CR/LF CR CR CR
Baud Rate
9600 9600 9600 9600
Parity None Even None Odd
Hardware Handshaking None RTS/CTS
Option 3 None RTS/CTS
Option 3
Software Handshaking None None None None
Serial Response Time-out 2 Sec. 9.9 Sec. 2 Sec. 9.9 Sec.
Stop Bit Select
One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit
Beep On <BEL> Disabled Disabled Disabled Disabled
RTS Line State Low High Low *Low = No
data to send
*In the Nixdorf Mode B, if CTS is Low, transmission of scan data is disabled. When CTS is High,
bar code data is transmitted to the host.