Symbol LS 4071, Product Reference Manual

Page: 21 / 168

2-3
Set Up
Charging the Battery
Before its first use, the LS 4071 batteries must be charged. To do so:
1. Connect the power supply to the power input jack on the RL 47X base
station.
2. Connect the power supply to a receptacle supplying AC power of the
proper voltage level.
3. Insert the scanner into the base station, so that the nose of the scanner and
tip of the handle seat into the receptacles.
Figure 2-3. Placing the Scanner into the Base Station
4. Check the charge status indicator light. See table on page 4-6.
5. The battery pack will fully charge within 2 hours. When fully charged,
proceed with pairing, as described on page 2-4.
As a charging stand, the base station recharges batteries in the scanner when
the scanner is in the cradle. The status of the scanner battery module
determines the charge rate. If the battery module is at or near full charge, the
base station supplies a trickle charge. If the battery module is at less than full
charge, there is a programmed charge. Note that the scanner can be removed
from the base station at any time.