Sygonix 2380477, Operating Instructions Manual, Page: 22 / 32

22
1) Resetting the access system and paring master transponder
•
De-energise the access system and wait for the LED to go off.
•
Press and hold down the door opener button.
•
Energise the access system. The access system will emit two beeps. Now release the door opener button.
•
The yellow LED will light up.
•
Hold the transponder to be paired as a master transponder in front of the RFID sensor. Once the transponder is
recognised, the access system emits a beep and the transponder is saved as a master transponder.
The used transponder that is already paired as the user transponder cannot be used as a master
transponder. The access system will emit three brief beeps and the LED will flash red.
•
When the red LED lights up, the access system is in standby mode. All the settings have been reset to factory
defaults.
2) Resetting the access system without paring master transponder
•
De-energise the access system and wait for the LED to go off.
•
Press and hold down the door opener button.
•
Energise the access system. The access system will emit two beeps.
•
Wait about 10 seconds, keep the door opener button pressed and do not release it.
•
The access system will emit a beep and the red LED will light up.
•
You can now release the door opener button for the access system to go back to standby mode. All settings have
been reset to factory defaults and there are no master transponders for pairing or deleting user transponders.
Table with default settings:
Function See chapter Factory setting
Master code 8. b) 123456
Changeover contact activation time 8. f) 5 seconds
Protection against incorrect entries 8. g) switched off
Alarm time for protection function 8 h) 1 minute
LED indicator 8. i) enabled
Beep 8. i) enabled