• Press the key on the remote control. The LED indicator (2)
will turn orange. The code lock is now in delete mode.
• Hold the fingerprint that you want to delete from the code lock
system on the fingerprint sensor.
• When the fingerprint has been detected, the code lock will
emit a beep and the LED indicator (2) will briefly turn green.
The LED indicator will then turn orange again.
• The user fingerprint has now been deleted.
If the fingerprint was not recognized or cannot be found
in the code lock memory, the code lock will emit 3 short
beeps and the LED indicator (2) will flash red before
switching back to orange.
• You can now delete another user fingerprint. Simply hold the
finger on the fingerprint sensor as above.
• To end the deletion process and exit programming mode,
press the key. The LED indicator (2) will switch to constant
red to indicate that the code lock is in standby mode.
h) Deleting a user transponder
• The code lock must be in standby mode and the LED
indicator (2) must be red.
• Enable programming mode (see section 11 "Programming",
paragraph "b) Enabling/exiting programming mode"). The
LED indicator (2) will then flash red.
35
