SY SY-HX150-44-18G, User Manual

Page: 8 / 36

sy.uk 8 V1.0
Connecting to the Matrix
1. Connect the HDMI sources to the HDMI inputs
2. Connect the Xcalibur 11 receivers to the HX outputs
3. Connect HDMI display devices to the Xcalibur 11 receivers
4. If required, connect local HDMI displays to the HDMI outputs
5. Connect any other signals such as IR, audio or control inputs
6. Power up the matrix
RJ45 Wiring
Both connectors must be wired identically.
IMPORTANT: The signals used by this extender set will not pass through any Ethernet device.
The Matrix and Receivers provided in this set will only work with the Xcalibur product range.
Please make sure that the Cat6 cable uses 4 pairs of 23AWG solid copper wires. Do not use
inferior copper clad cables as these exhibit high resistances.
It is recommended for the HX cable run between the Transmitter and Receiver units to be
continuous cable run of either cat5e/6/6a. Cat6a cabling is preferred for best signal quality.
IR Connector Wiring
The following diagrams detail the IR Eye/Emitter wiring connections for the Xcalibur matrix and
the Xcalibur-11 Receivers.
Figure 1 - Xcalibur IR Eye
Figure 2 – Xcalibur IR Emitter
Figure 3 - IR Eye Connector Wiring Figure 4 - IR Blaster Connector Wiring
The IR emitter (blaster) connector can be a 3.5mm mono style, in which case the entire sleeve
is the +ve signal. IR signals with a carrier frequency in the range of 25-60 KHz can pass through.