SY SY-HX150-44-18G, User Manual

Page: 14 / 36

sy.uk 14 V1.0
System Commands
RS232 Command Description Response Example
s reboot! Reboot the matrix switcher. Reboot… (note 1)
s reset! Restore the matrix unit to factory defaults. Reset to factory defaults
(note 1)
r fw version! Get the installed firmware versions.
MCU BOOT: Vx.xx.xx
MCU APP: Vx.xx.xx
help! List all available commands. (note 2)
s power z!
Set the power state of the matrix,
z = 0 power off z = 1 power on
power on
r power! Get the matrix power status Power off
r type! Get the matrix type SY-HX150-44-18G
r status!
Get a report of the current status of the
matrix unit
(note 3)
r link in x! Get the connection status for input x . hdmi input 3: connect
r link out y!
Get the connection status for output y . Note
that both the HDMI and HX outputs are
reported on separate lines.
hdmi output 2: disconnect
hx output 2: connect
s beep z!
Set keypress buzzer sound.
z = 0 beep off z = 1 beep on
beep off
r beep! Get the key beep mode current status. beep on
s lock z!
Set the front panel lock status.
z = 0 unlock z = 1 lock
panel button lock on
r lock! Get the current front panel lock status. panel button lock off
s lcd on time z!
Set the dwell time that the front panel LCD
remains on.
z = 0 always off z = 1 always on
z = 2 15 seconds z = 3 30 seconds
z = 4 60 seconds
lcd on 30 seconds
r lcd on time! Get the lcd on time. lcd on always
s logo1 ******!
Set the product name displayed on the LCD to
the text in ******. The text is limited to a
maximum 16 characters
logo1:SY-HX150-44-18G
s baud rate xxx!
Set the baud rate for control commands
where xxx is the desired baud rate
(note 4)
Baudrate: 115200
r baud rate!
Get the current baud rate for control
commands.
Baudrate: 115200
Notes:
1. The “ s reboot! ” and “ s reset! ” commands both respond with System initialising…
followed by several other messages.
2. The “ help! ” command lists all available commands present in the installed firmware
version. This list is too long to present as in this document, but each command is
detailed individually in its own section.
3. The “ r status! ” command returns a very detailed report of all the settings and current
configuration of the matrix unit.
4. For the “ s baud rate xxx! ” command, only the following baud rates values are valid for
xxx : 4800, 9600, 19200, 38400, 57600, and 115200.