MHDBT-88P
sy.co.uk
12
Command Code
Function
EDIDUpgrade[x].
Upgrade EDID data via the RS232 port.
[X] is for input port, when the value of X is 9, it means to upgrade all
input ports. When the switcher receives the command, it will show a
message to prompt you to send EDID file (.bin file). Operations will be
cancelled after 10 seconds. Please cut off all connections of HDBT ports.
UpgradeIntEDID[x].
Select one of the built-in EDID data blocks for upgrade. There are 4 built-in
EDID data blocks:
1. 1080P, 2D, PCM2.0
2. 1080P, 2D, 5.1 (audio)
3. 1080P, 3D, PCM2.0
4. 1080P, 3D, 5.1 (audio)
[x] = 1, 2, 3 or 4
When the switcher gets the command, it will show a message requesting
an EDID file (.bin file). Operations will be cancelled after 10 seconds.
EDID/[x]/[y].
Set the built-in EDID data of input port [x] to type [y].
The value of [y] is 1, 2, 3, and 4. The EDID data types are as stated above.
%0801.
Automatic HDCP management. If the input has HDCP, so does the
output.
%0900.
Set as infrared carrier following mode.
%0901.
Set as infrared carrier enforcing mode.
%0911.
Reset to factory default.
%9951.
Check the command sent by port 1 when PWON.
%9952.
Check the command sent by port 2 when PWON.
%9953.
Check the command sent by port 3 when PWON.
%9954.
Check the command sent by port 4 when PWON.
%9955.
Check the command sent by port 5 when PWON.
%9956.
Check the command sent by port 6 when PWON.
%9957.
Check the command sent by port 7 when PWON.
%9958.
Check the command sent by port 8 when PWON.
%9941.
Check the command sent by port 1 when PWOFF.
%9942.
Check the command sent by port 2 when PWOFF.
%9943.
Check the command sent by port 3 when PWOFF.
%9944.
Check the command sent by port 4 when PWOFF.
%9945.
Check the command sent by port 5 when PWOFF.
%9946.
Check the command sent by port 6 when PWOFF.
%9947.
Check the command sent by port 7 when PWOFF.
%9948.
Check the command sent by port 8 when PWOFF.
%9961.
Check the system locking status.
%9962.
Check the status while in standby mode.
%9963.
Check the working mode of infrared carrier.
%9964.
Check the IP address.
%9971.
Check the connection status of the inputs.
%9972.
Check the connection status of the outputs.
%9973.
Check the HDCP status of the inputs.
%9974.
Check the HDCP status of the outputs.
%9975.
Check the switching status.
%9976.
Check the output resolution.
%9977.
Check the status of digital audio of output channels.
%9978.
Check the HDCP status of the input ports.
Note
:
1)
Please disconnect all the twisted pairs before sending command EDIDUpgrade[X].
2)
In above commands, [ and ] are symbols for easy reading and do not need to be typed in the actual
command.
3)
Please remember to end the commands with the correct ending symbol . or ; as shown in the
commands above.