− Telephone Answering Machine −
135
10
Telephone Answering Machine
If the answering machine has already taken the call, you can take the
call at any time by pressing the Call button
. Recording of the
message is automatically stopped in this case.
10.1
Switching the telephone answering machine on/off
If the answering machine is switched on, it takes the incoming call after a
predefined number of rings (refer to 10.4).
On
or
OF
Switch the answering machine on/off
10.2
Maximum recording time
The answering machine can digitally save up to 60 incoming messages
with a total length of 19 minutes. The maximum length for each incoming
call is 2 minutes. When the memory capacity for incoming messages is
used up, no further messages are recorded.
10.3
Setting the volume on the answering machine
If the volume of the answering machine is too high or low when playing
back messages or listening−in to incoming calls, it can be adjusted to
one of 5 levels.
z
or
y
Set the volume
10.4
Delay taking the call
It is possible to set the number of times the telephone should ring before
the answering machine takes the calls. It can be set to between 2 and 7
rings (
r2
to
r7
). In addition, the toll−saver" setting (
tS
) is available
to use the free pre−remote access function (refer to Chapter 10.12).
2 sec
Press button
z
or
y
r2
to
r7
or
tS
,
Select the setting and confirm
10.5
Message alert signal for recorded messages
As soon as an incoming message or a memo has been recorded, an
acoustic signal is issued once a minute to indicate this.
x
On
or
OF
Switching the indicator signal on/off
