20
40
00
32
en
_b
a_
a0
58
Range beep
This function is only available on the
handset (“Handset settings” submenu). In
call mode, a warning beep sounds on the
handset if you leave the radio range.
If this happens, move back toward the base
station or out of the blind spot until the
warning tone stops, otherwise the tele-
phone connection will be disconnected.
Note:
If the range is insufficient, relocation of the
base station may improve the range.
See the section “Setting up the telephone
and putting it into service” for information
about the optimum location.
Charging beep
This function is only available on the
handset (“Handset settings” submenu).
The charging beep is on by default. An
acknowledgement tone sounds when the
handset is replaced in the charging bay.
Device settings
Direct accept
This function is only available on the
handset (“Handset settings” submenu).
Incoming calls are accepted directly by
simply lifting the handset from the charg-
ing bay.
Note:
If the handset is not in the charging bay,
calls can be accepted by pressing the
connect key. If the answering machine is
recording a message, direct accept is
temporarily off.
Backlight
The display is backlit as soon as a key is
pressed or there is an incoming call. If no
key is pressed for several seconds, the
backlighting is automatically switched off.
Automatic DTMF
This function automatically switches to
DTMF when a connection has been estab-
lished.
Summary of Contents for Eurit 595
Page 102: ......
