Swissphone Telecommunications AG
manual RE529.doc
July 14
th
2003
Fälmisstrasse 21 // 8833 Samstagern
edition 0.9
Switzerland
PMA/D000xxx
page 5/7
2.5 Volume
The announcement volume can be adjusted to 4 levels. (The volume of the call signal, however, is
unaffected). With key (1), select the volume symbol. Using key (2), you can now select the desired
level 1, 2, 3 or 4, which you can then acknowledge with key (1). Level 1 is the quietest level, and level 4
the loudest. Level 3 corresponds to the nominal volume.
2.6 Field Strength Alarm
Functional in radio networks with cyclical transmission sensing only.
This symbol appears as soon as you are no longer within the reception range. In addition, a short term,
acoustic beep signal sounds at regular intervals (depending upon the acoustic setting, this could
possibly only be a vibration signal).
You have the possibility of switching the field strength alarm off. Select the menu symbol Field Strength
using key (1). The symbol starts to blink. Now acknowledge the Field Strength Alarm OFF by pressing
key (2). The field strength symbol is no longer visible. By incorrect reception, the field strength alarm
will only be indicated optically in the display. The acoustic field strength alarm can be switched on
again in the same way. After confirmation (1), the field strength symbol remains visible for about 8
seconds, and then disappears if the field strength is sufficient.
2.7 Address Display
This 3 digit display serves as an address display. This free programmable character can be assigned
to the max. 8 addresses of the pager. They will appear during the alerting of the proper address, during
retrieving of the proper call and during switching ON and OFF of the proper address.
2.8 Switching ON and OFF of the Activated Addresses
After the selection of the menu "
Adr
" it starts to blink. Now You will display the first activated address
by pushing the execute button. Ist sign (number, character i.e.) appear in the display. Simultaneously it
will appear the sign ON or OFF depending of the current status (switched ON or OFF) of the address.
Both "
Adr
" and the status (ON or OFF) are simultaneously blinking. Now You can during the blinking
change the status with the execute push button which has a toggle function. With select button You
can continue to the next address. In the case that after the selection of the "
Adr
" the signs ON and
OFF does not appear in the display means that this address is not set by programming to be
switchable.
2.9 Message
After the selection of this symbol with the select button you can retrieve all current stored voice
messages. (Memo pagers only).
