background image

Swissphone Telecommunications AG 

manual RE529.doc

July 14

th

 2003

Fälmisstrasse 21 // 8833 Samstagern

edition 0.9

Switzerland

PMA/D000xxx

page 3/7

1.5  Switching On / Keys

If the unit is switched off, you can switch on the pager operation by 

simultaneously 

pressing both

operating keys SELECT(1) and EXECUTE(2). 

As a rule, a self-test takes place every time the unit is switched on, and briefly displays the following
check pattern.
1)  Display of the programmed operational functions by symbols

in the display and sequential display of enabled addresses.

2)  Control beeps
3)  The LED lights up
4)  Short-term vibration

1.6  Selecting the Operating Status

The operation of the unit is very simple and ergonomic, and is designed for a high level of operational
security. The keys are located in the upper left and right corners of the unit. The left-hand key (1) is
SELECT, and the right-hand key is EXECUTE.
With the left-hand key (1), you can select the desired operational symbol. The symbol begins to blink.
Using the right-hand key, the desired operational function can be acknowledged, and the symbol
ceases to blink in the display. The sequence takes place depending upon how the symbol selection
has been defined in the programming. Only those symbols will be sequentially displayed which have
been enabled in the programming.
After a call was found valid, the speaker is switched on to monitor the air traffic. Pressing any key will
just mute the pager. In case of a memo pager, voice recording will continue. Otherwise the pager stays
on loud until squelch overrun time is exceeded. 

select (1)

execute (2)

KEYS

Quattrino EURO

ON OFF

BAT

T

E

R

Y

Summary of Contents for Quattrino RE529 two tone








Reviews: