Swissphone Telecommunications AG
manual RE529.doc
July 14
th
2003
Fälmisstrasse 21 // 8833 Samstagern
edition 0.9
Switzerland
PMA/D000xxx
page 4/7
2 The complete LC Display of your unit
2.1 Acoustic ON
Incoming calls will be signalled simultaneously with a call signal and a vibration. In addition, the light
display blinks in the upper left corner. Following these signals, you will hear the spoken announcement
via the loudspeaker.
2.2 Mini-Beep
Incoming calls are indicated by the vibrator, and then with short beep tones. The LED in the upper left
corner also blinks. Finally, following these signals, you will hear the spoken announcement.
2.3 Acoustic OFF
Incoming calls are signalled only by the vibrator. There is no acoustic alarm, and no spoken
announcement is heard.
2.4 Monitor
In this operational mode, you can hear everything that is spoken over the set radio channel. Calls
addressed to you will be signalled "acoustically". If you wish to switch off the continuous monitoring /
listening operation, select one of the acoustic symbols with key (1), and confirm this with key (2).
Notice
to the point 3.1 until 3.4
Pager with the voice memory will record the spoken message than when with the proper programming
voice memory has been assigned to the proper address and alarm type has been set to "Voice" or
"Tone and Voice" status. In monitor mode spoken message will be only recorded when proper address
has been activated. Due to the programming, voice memory can be assigned fix or dynamically to the
address. The total recording time of 240 sec can be set to portions of 20, 30, 40 or 60 sec.
battery recognition
ON OFF
BA
T
T
E
RY
acoustic ON
call recognition
battery status indicator
volume adjustment
message
field strength alarm
3 digit display
ON / OFF sign
for different functions
Minipiep
acoustic OFF monitor
acoustic ON
