Swisscom Aton CLT418ISDN, User Manual

Page: 14 / 76

12
2040522
3en_
ba_b0
Setting up the telephone
You can use a repeater to extend the range and receiving power of your base station.
The repeater must first be registered and activated on the base station. (Your
telephone is delivered with the default setting "off").
Note  For settings refer to chapter "Settings, Repeater".

Repeater and Ecomode plus mode are mutually exclusive.

Do not expose the base station to direct sunlight.

Protect the base station against moisture. Do not position the base station in
rooms exposed to condensation, corrosive steam or excessive dust. Condensation
can be pre-sent in basements, garages, conservatories or sheds.
 The ambient temperature must be between 5 °C and 40 °C.
Position the base station in a clean, dry and well-aired location. Choose a place which
is stable, level, and not subject to vibrations. To avoid mutual interference, do not
position the base station in the immediate vicinity of electronic equipment such as
hi-fi systems, office equipment or microwave ovens. Avoid positioning the telephone
near heat sources such as heating elements or near obstacles such as metal doors,
thick walls, niches and cupboards.
There is no mains switch on the base station. For this reason the socket to which it is
connected must be easy to access.
When you are on the telephone, the base station and handset are connected to each
other over a radio link. The base station handles switching between the telephone
network and the handset. To ensure that no-one can eavesdrop or telephone at your
cost, the base station and handset exchange codes. If the codes do not match, the
connection with third-party handsets cannot be set up.