MV-1056-11-2018 .
swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS
51
UK
4. Startup and settings
Power LED:
Push the green reset button on
the RCD of the heat pump. The
Power LED will turn on, indicating
the heat pump is ready to start
Outdoor socket
Fan LED:
Fan LED is on
indicates the fan is
running. Fan LED is off
indecates the fan is not
running.
Display:
Shows the current water temperature.
Following error messages occure in case
of a problem:
Ambient air temp. is
below 10°C.
One of the heat pump
sensors in damaged.
Pressure of the com-
pressor is too high.
Settings LED:
Set light indicates your in the set-
tings menu. This menu will close
and save any changes automatically
after 10 seconds.
ON/OFF:
Press the ON/OFF button to start the heat
pump. The current water temperature will ap-
pear and the heat pump will start automacitally.
The heat pump won’t start when the desired
water temperature is reached. Meanwhile the
current water temperature is shown on the
display. The heat pump will start automatically
when the water temperature drops 1°C below
set point.
Press the ON/OFF button to stop the heat
pump.
Operation LED:
The heat pump is equiwith a 2min30sec built-
in compressor delay to protect control circuit
components. Each time the compressor is
switched on the timer starts to count. Opera-
ting LED is blinking, indicating the heat pump
isn’t using the compressor at current moment.
Operating LED is active, indicating the heat
pump is using the compressor at current mo-
ment.
Temp. UP:
Press to increase desired
temperature. This menu
will close and save any
changes automatically
after 10 seconds.
Temp. DOWN:
Press to increase desired
temperature. This menu
will close and save any
changes automatically
after 10 seconds.
