50
MV-1056-11-2018 .
swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS
UK
3.3 Set-up
Pump
Pool outlet
Pool inlet
Filter
HotSplash
Watercare
3.4 Electrical connection
Before the heat pump is connected, check that the power supply matches the operating
current of the heat pump. The heat pump is supplied with an RCD integrated mains plug,
which provide electrical protection.
3.5 Initial procedure
NOTE
The heat pump has no pump. In order to be able to heat the water, the filter pump
must be in operation. It is the filter pump that directs the water through the heat
pump and the HotSplash cannot start if the water is not circulating.
When everything is connected and has been checked, go through the following points:
• Turn on the filter pump. Check for leaks and make sure that the water is flowing to
and from the pool.
• Connect the power to the heat pump. The unit will start when the time delay has ex-
pired.
• After a few minutes, check if the air that is being blown out of the unit is cooler.
• Check that the heat pump stops automatically when the filter pump is switched off.
