9
FB 270 / FB 280 / FB 300
B00019
B00005
1
2
3
4
5
6
7
8
9
D
oc: 101542-
GB 2105-
BEFORE STARTING
See “DAILY SUPERVISION”, page 7.
Attach the strap (1) that is located together with the
ignition key (2) in a suitable place in the operator’s
clothing.
This is an important safety feature, since the key acts as
a dead man’s switch and will be pulled out of position
and stop the machine if the operator loses control.
The key is unique and only works for your machine if it is
not programmed to work for other machines, e.g. within a
work area.
Control panel
1. Vibration switch, push the switch to increase the
engine speed and begin compaction.
2. Start/Reset switch, press and hold the switch there
for 1 second, the machine will begin to idle.
3. Switch for handle heating, push in the switch to heat
the handle when the engine is running (Some ma-
chines).
4. Indicator lamp “Charging”, red when battery is low.
5. Oil pressure Warning Light, red when oil pressure is
low (after having displayed red, the control system
must be reset by holding down the Start/Reset switch
for 7 seconds).
6. Fuel Level Warning light, green when full, yellow
when half-full and red when the tank is empty. When
the light is red, refill fuel. Tap the machine’s oper
-
ating lever lightly and the last measured value will
be displayed even when the engine is switched off
(Some models).
(NOTE! The engine is switched off before the fuel
tank is completely empty, which means that the fuel
system does not need to be vented after stopping due
to lack of fuel).
7. Air Filter Warning Light, shines red when the air
filter is clogged (some models).
8. Hydraulic Oil Temperature Warning Light, shines
red when the hydraulic oil temperature is too high
(the warning light is present on all models, but is
only used on certain models).
9. Swepac Compaction Indicator (SCI). The lights are
turned on from left to right as compaction progresses
(some models).
