10
FB 270 / FB 280 / FB 300
B00019
B00007
B00020
D
oc: 101542-
GB 2105
The machine is only intended for outdoor use. Operate
the machine in daylight or other adequate lighting.
Ballast must be wetted or naturally damp. All other
uses are advised against.
Note! When driving uphill, the machine should be
driven in reverse.
The machine may not incline more than 20º sideways
or during installation.
Lever heating
Some machines are equipped with lever heating. The
lever heating is activated by the lever heating switch on
the control panel: The lever heating
can only be used when the engine is running
in order to prevent the heating coil from wasting the
battery when the machine is not in use.
Driving in reverse
Driving forward
STARTING THE MACHINE
Put the key in its slot on the control panel. Press the
Start/Reset switch, press and hold the switch there
for 1 second, the machine will then start. Let the
machine idle for at least 30 seconds before pressing the
vibration switch to activate it and begin working.
If the machine has difficulty starting, e.g., in cold
weather, keep the Start/Reset switch down for a period
of time and the starter motor will start up in 15 seconds
If the machine still won’t start, check the following:
• is there fuel in the tank?
• is the battery charged?
• if the machine is programmed to be used within a
specific area, make sure you are not outside the area.
• if the machine still will not start, try resetting the
machine’s control system by holding down the Start/
Reset switch (2) for 7 seconds.
• contact service repairman
STOPPING THE MACHINE
Press the vibration switch (1) once to stop vibrations
and then press the Start/Reset switch (2) once to stop
the machine. Retract the starter key.
EMERGENCY STOP/ DEAD MAN’S
SWITCH
(Some machines)
Retract the starter key to stop the machine immediately.
DRIVING INSTRUCTIONS
Start and stop the machine’s vibration element with the
vibration switch on the control panel.
When the control bar on the handle is pulled
backwards, the machine reverses and when the bar is
pressed forward, the machine moves forward.
Note! When packing, always run the engine at full
throttle.
Max 20°
