
7
b.
Remote control settings
i.
Interface description
This interface is used to set the receiver type of the remote controller, test and calibrate the
remote control channel, set the remote control flight mode and out of control protection.
[1] Remote control interface assistance statement.
[2] Receiver type setting box is used to select the receiver type of the remote controller.
[3] Automatic return channel status display box, corresponding to the sixth channel of the
remote control
[4] Rocker alignment box corresponds to first to fourth channels of the remote controller for
Setting remote control channels, forward and reverse, and rocker calibration.
[5] Rocker reverse setting button, click the corresponding channel will reverse.
[6] Rocker calibration button, click into the rocker calibration.
[7] Flight mode status display box corresponds to the fifth channel of the remote controller
for displaying and modifying the flight control mode.
ii.
Receiver type selection
The receiver defaults to SBUS, and no other settings are required.
iii.
Remote control calibration
Splash Drone 3 remote control receiver type is SBUS. The remote controller has been cali
brated before leaving the factory and does not need to be calibrated again under normal c
onditions. If you find the middle,maximum and minimum amount of rod is inconsistent with
the software interface, please click the "Joystick Calibration", push the two joysticks rotate
along the outermost part for several turns,then release the joysticks and click "Complete C
alibration", click "Complete Calibration" again. Check the prompt up parameter. If the Min i
s 1064±5, middle is 1500±1, max is 1980±5, the calibration is successful.
Matters needing attention:
Summary of Contents for Splash Drone 3
Page 1: ...1 Flight Control and tuning Manual...
Page 17: ...17...