Swegon TACtouch, Operation And Assembly Manual

Page: 5 / 15

5
8.
Software update
Possibility to update the control panel software
via memory card microSDHC inserted in the slot
in the panel interface.
In order to replace a program, the TAC5/TAC6
controller’s electric power supply should be
disconnected. Insert the memory card into the
slot in the panel control. The card should contain
new software in a *.pfc format. New software
should be copied directly to the memory card,
not to a subfolder. Connect the electric power to
the TAC5/TAC6 controller and open software
update from main menu and replace the
program in the control panel.
9. ASSEMBLY
9.1 Technical data
Power supply 5..24 VDC
Consumed current
at
12V supply voltage
120 mA
Protection class IP20
Work/storage
temperature
0..50  C / 0..65  C
Relative humidity
5 … 85%, without
condensation
Display
Graphic, color
480x272pix with
touch panel
Terminal
Ver.1: RJ11
Ver.2: Screw
terminals. Cross-
section: 0,2..1,5 mm
2
Dimensions 96.8x148.8x14.5 mm
Weight 0.2 kg
9.2 Exploitation conditions
Control panel:
• do not expose the device to direct influence
of atmospheric conditions (rain, sunlight)
nor vibrations stronger than typical
occurring during wheel transportation.
• do not use the device in vapor condensation
conditions and protect it from water.
• storage and transportation temperature
should not exceed the range of
-
15… +50°C.
• install the device only in dry residential
room.
9.3 Assembly requirements
Recommendations:
• panel is intended for wall installation inside
compartments.
• assemble the panel at a height of approx.
1.5 m above the floor.
• avoid highly insolated areas with poor air
circulation, near heating devices.
• panel should be installed by a qualified
installer.
Only microSDHC (FAT32 files format, 32GB
max.) type memory cards should be used
.