24
MAINTENANCE AND SERVICE
REPLACING BRUSh SECTIONS
1.
Remove four motor mount studs and klik
pins. Retain hardware for reinstallation.
Remove motor bucket mount with motor
and the hex receiver plate.
2.
Remove bearing assembly: Remove four
bearing mounting studs and klik pins,
center capscrew and bolt on idler shaft.
Retain hardware for reinstallation.
3.
Lift sweeper body leaving core on
ground.
4.
Remove the core retainer plate. Retain
hardware for reinstallation.
5.
Remove old sections.
6.
Install new sections:
a. Number the tubes on the core as 1,2 and 3
(FIGURE 1).
b. Slide the first section onto the core with the
drive pins on either side of tube 1. Make
sure that the drive pins angle up (FIGURE
1).
c. Place the second section on the core with
the drive pins on either side of tube 2. Be
sure the drive pins angle down (FIGURE 2).
d. Put the third section on with the drive pins
around tube 3. Be sure the drive pins angle
up.
e. Slide sections on until the core is full, mak-
ing sure to alternate the tubes used and the
direction of the drive pins.
7.
Re-attach the core retainer plate.
8.
Lay core on ground. Lower body over
core.
9.
Re-attach the bearing assembly with
hardware previously removed in step #2.
10.
Attach receiver plate and motor bucket
mount with hardware removed in step
#1.
DRIVE PINS
DRIVE PINS
CORE
1
1
2
2
3
3
TUBES
FIRST SECTION
SECOND SECTION
FIGURE 1
FIGURE 2
Summary of Contents for 240 series
Page 2: ...2...
Page 4: ...4 THIS PAGE IS INTENTIONALLY BLANK...
