Message Transmission
SOMETHING BROKEN OR MISSING?
CONTACT SWARM CUSTOMER SUPPORT:
TECHSUPPORT
@
SWARM.SPACE
1.
Open a Serial or Telnet connection from your device to the Kit
a.
If connected via USB-C, use serial terminal (Putty/
*Note: Ensure the Feather/USB serial connection jumper is configured
for the type of connection being made.
for reference to the jumper configuration.
For serial, use baud rate 115200, config 8-N-1, with flow control None
b.
If connected wirelessly, use Telnet to the Feather IP address
i.
for this on Windows/macOS
2.
Send the following commands to the feather:
a.
@set ssid YourSSID
i.
Response: Successfully set ssid to YourSSID
b.
@set pw YourSSIDPassword
i.
Response: Successfully set pw to YourSSIDPassword
c.
@set mode sta
i.
Response: Successfully set mode to sta
d.
@reset
i.
Response: No response, Feather will reboot and a new IP
address will be displayed
ii.
ST: xxx.xxx.xxx.xxx will now be displayed on OLED screen.
3.
Switch your computer or phone WiFi connection to YourSSID
4.
Re-connect via Telnet using the new displayed IP address
5.
You’re now ready to send commands to the Eval kit in STA mode!
i.
Swarm M138 Modem Product Manual
command options.
St
a
tion (STA) Mode
Users can to change the Eval Kit to Station (STA) mode, to connect to a
common access point such as a home WiFi network.
You’ll need to send commands via a Serial or Telnet terminal while connected to
the Eval Kit to change to STA mode.
SWARM EVALUATION KIT QUICKSTART GUIDE
PAGE
13
© 2022 SWARM TECHNOLOGIES
