2.1 GETTING STARTED
2.1 GETTING STARTED
GETTING STARTED
GETTING STARTED
10
Connect all the devices to construct a surveillance.
1)
Install HDD:
The HDD must be installed before the DVR is turned on. Please refer to Appendix #1 for
HDD installation instructions.
2)
Connect cameras, monitors and external devices. Please refer to “Section 1.5 Rear Panel”
for connection, and Appendix#2 for pin configurations of the external I/O port.
NOTE:
Be sure the cameras are connected and power-supplied before the DVR is
powered on. Otherwise the DVR will not be able to detect N/P system automatically.
3)
Connect the AC power cord to power adapter and plug into an electrical outlet.
The standby LED would be on as red. Press the “POWER” button.
The power LED will be on as red.
It takes approximately 10 to 15 seconds to boot the system.
Channel Title
Available Capacity of
Internal HDDs
System Time
Under HDD Overwrite
Mode
Take 16CH as an example
Take 16CH as an example
