steam ironing
1. Fill water tank with clean tap water refering to the filling instructions.
For better performance, please immerse filter in water for several minutes
before installing it into the water tank.
2. Connect the appliance to a suitable socket outlet. The power indicator light
(red) “ ” will light up on the iron unit showing that the unit has been connected
to the power supply.
3. Set selection button to desired position according to fabric setting chart
on page 08. The setting indicator light (blue) on the iron unit will blink slowly
to indicate the unit is heating up. When the blue indicator light changes to a steady
light and an audible “Bi” signal is produced, the desired temperature has been
reached and it is ready for steam ironing. During use, temperature indicator light
will sometimes blink and sometimes be a steady light. This does not indicate a
defect or hazard - this is because the appliance temperature is constant.
4. Before first use, clean the iron unit as following methods:
Take the iron up from the base unit, press steam button underneath the handle
to allow steam ON for 30 seconds, and then OFF for 30 seconds. This cycle
should be repeated for 2 times. When blue indicator light stop blinking, it is ready
for use.
5. During steam ironing, steam should be automatically adjusted according to
sole-plate temperature.
6. After use, put iron unit back onto the base unit again, set selection button to “ ”,
and then unplug the appliance from main socket .
7. Slide out the water tank and pour out the remaining water.
12
