4.4 MOTION DETECTION SETUP
Setting up the Motion Detection (
MD
) values, including the first area (red border) and second
area (green border).
Please check to see whether the Event Trigger has been enabled. If so, you can set up Motion
Detection as described below:
Reset MD range
: Select motion detect 1, and hold down on the left mouse button (this will
appear as the upper left corner of the MD range). Then, drag out the desired range and release
when finished;
Cancel MD
: Same as above, but just left click once and release. This will cancel the MD (Motion
Detection).
Motion_detec_set
: This sets the MD (Motion Detection) sensitivity, which is usually set to a
value of 5. This means that the motion detection will be toggled with as little of a 5% change in
the MD range. The lower the number entered, the higher the sensitivity of the MD.
When motion is detected, the screen should display an MD warning in red in the upper left hand
corner if there is movement within MD1 or MD2, as shown below:
- Any motion detection range can be selected in 640 x 480 and 320 x 240 resolutions;
- In 160 x120 resolution, the motion detection is fixed to the entire image.
-
-
-
The image will zoom in according to the dimensions entered and will show an image similar to
this below.
11
