www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
BEDIEUNUNGSANLEITUNG
/ INSTRUCTION
MANUAL
S3249
Safety instructions
1. In the case of a drive square with bore hole, the socket must be secured using a steel pin and rubber ring.
If the drive square is fitted with a spring ring, this must be checked for sufficient tension at regular intervals and
replaced if necessary. A socket which is not secured as described in the way described here can become loose
from the tool and cause damage. For this reason, never allow the pneumatic tool to rev up in idling gear if there
is a socket on the drive.
2. Only use sockets which are suitable for impact screwdrivers.
3. The pneumatic tool should only be used for loosening / tightening screws. Damage resulting from non-
observance of these instructions, improper use or manipulation of the tool is excluded from warranty
claims. We reserve the right to make technical changes.
4. Those operating the pneumatic tools are not allowed to wear loose clothing and must have long hair tied back.
- ACCIDENT HAZARD
5. Always wear ear protection, safety gloves and goggles.
6. Check hose connections for a firm fit. Do not use any damaged pressure hoses.
