www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
BEDIEUNUNGSANLEITUNG
/ INSTRUCTION
MANUAL
S3300
S3300
www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
BEDIEUNUNGSANLEITUNG
/ INSTRUCTION MANUAL
S3300
•
FORWARD/REVERSE LEVEL
WARNING
: Always check the direction
of rotation before operation .
This determines the direction of
rotation of the chuck, ie . clockwise or
anti-clockwise .
To alter the direction of rotation stop
the drill then push the
selection lever to the left of right .
When the lever is in the “Forward”
position the chuck will rotate
clockwise . When the lever is in the
“Reverse” position the chuck will rotate anti-clockwise . Before
operation check that the level is set in the required position .
(Fig . 4)
WARNING
: Use the reversing switch
only after the tool comes to a complete
stop . Changing the direction of rotation
before the tool stops may damage the
tool.
When not operating the tool, always set
the reversing switch lever to the neutral
position .
•
TRIGGER
3. To start the tool, simply press the
trigger . Tool speed is increased
by increasing pressure on the
trigger . Release the trigger to
stop . (Fig . 5)
4. When the trigger is de pressed
the chuck will rotate (provided
the forward/ reverse level is set in the forward or reverse
position) . The trigger can be locked in the OFF position .
This helps reduce the possibility of accidental starting when
not in use . To lock trigger, place selection lever in the
centre position .
•
HOW TO OPERATE THE IMPACT POWER
SELECTION
6. The impact power selection
button is used to adjust the
torque, rotation speed (RPM),
and impact speed (IPM) for
different application . Please pay
attention . Power modes are not
able to be switched when tool
being run .
7. Before you selecting the mode on
the top pad, please click out the
trigger to let electric current
through the pad for your
selection.
8. L/M/H three modes only be selected at forward
rotation, L/M/H three modes and
mode (R
mode) are selected at reversed rotation . When the
letter you press is lighted, the tool is ready to work .
(Fig . 6A)
9. The lighted alphabetic symbols during operation are
shown as battery capacity the tool remains . The
lighted alphabetic when trigger released is shown
what speed mode the tool stays .
10. When 4 lights flash at once it symbols either the tool
or the battery failed . Please check carefully .
(Fig . 6B)
INDICATOR LIGHTS
Lighted
OFF
Impact force grade
displayed on panel
Approx .
rpm / ipm / torque
0~1,900 rpm
Work
0~1,900 rpm
0~2,400 ipm
650 Nm
Heavy duty
fastening
0~1,200 rpm
0~1,600 ipm
400 Nm
Moderate duty
fastening
0~900 rpm
0~1,200 ipm
200 Nm
Light duty fastening
Automatic
adjustment by
PCB
“R Mode“
for nuts in case fly
out at high speed
Fig. 4
Fig. 5
Trigger
Fig. 6A
Light
Button
Fig. 6B
